![]() ![]() Then recode with the manipulation profile the four parameters in the KOMBI again and that should do it. If you have any doubts just go back and default code the KOMBI, NFRM, JBBF, and CIC. It sounds like you may have lucked into getting it right anyways if you have no errors and the tach is working correctly. In order to code and program any bmw feature, you need to setup the so called 'expertmode' profile so in this video I will show you how to set it up. My profile names are factory coding and manipulation, can't get them confused. The expertmode profile is always named 'default' once you install the INPA and NCS Expert. Keep one that has manipulation checked and one that doesn't and since you found the profile editor open the profile info box and change the profile name of each to something that you know will differentiate between the two. Look to see if $2TC is gone and $2MK is there, they'll be at the front of your VO just a few characters in.Ĭheck your other profiles. Check your VO, it will show in NCS Expert after you pick CAS and hit back in your initial read. It's just easier to have the two different profiles rather than going back and forth changing one to fill both needs. Usually there's two or three profiles listed, what are the names of yours? Keep in mind the profile name can be changed to anything you want. One single installation will install ALL the programs needed for coding & diagnosis, will update the programs to show English menus, will set up NCSExpert with the correct NCSDummy profile, will automatically install USB Drivers, and comes integrated with SP-DATEN 53. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |